Panigale V4 Club banner

1 - 2 of 2 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter #1
I have the Arrow exhaust and it asks you to loosen the headers so you can get the stock muffler off - it's kind of wedged in there with the headers in 2 directions, so that makes sense.


Q - how on earth do you get the header bolts loose ? 4 are easy enough with a 1/4 drive ratchet, flexible coupling and 8mm socket, but the upper right and lower - inner - left seem virtually impossible to access. Suggestions most welcome please.


Thanks


Robert @ bleeding knuckles
 

·
Registered
Joined
·
3 Posts
In case someone stumbles upon this thread like I did.

I just installed Termi slip-ons & UPmap. They shouldn't use the term "slip-on"...it was a project for sure. Mostly because the instructions were HORRIBLE.

Anyway, Termi also said to loosen headers, but I didn't, and didn't experience any problems with installation by not loosening them. Can't speak for the Arrow kit and what affect you'd experience by not doing this step.
 
1 - 2 of 2 Posts
Top